Initial boots to garbage:
Reseat all socketed chips and now boots to ram error and flipped image:
Replaced and socketed RAM at 9-P:
Rebooted, and still get VRAM error at 9-P.
Did visual inspection of area around 9-P and noticed some damaged traces
on the board (in hindsight, should have done this first)
Got out the meter and did continuity tests on all of the traces and found a bad one (red arrow)
Ran a jumper wire to bypass the broken trace:
Booted up and get this screen:
Jumper for test mode was switched on. Turned it off and...
No comments:
Post a Comment